Can't connect two computers through pfsense router
-
If your CPU is (almost) pegged, I'd guess you are not going to get much more than that.
-
Hmm…
But why can the desktop transfer a lot faster? That one also has a singlecore Atom (230), same as the motherboard of the pfsense router.
-
If you are seeing 380Mbit through pfSense, then you are really seeing that * 2 = 760Mbit of throughput. 380 in, 380 out.
-
Also…
Also noticed something in the firewall log. The desktop (on wan) is sending something via UDP through port 138 to 192.168.0.255, beneath action is shows a white x in red box.
That's standard Windows NetBIOS broadcasts. It must not be allowed by any rules you have specified if it's showing up in the firewall log as blocked.
-
Uhm, so I have to delete the NAT and firewall rule that I made and that is supposed to let them get through?
O wait, just realized, I forwarded that port to the IP of the laptop, while they are directed to 192.168.0.255.Should I even let those packages get through?
If you are seeing 380Mbit through pfSense, then you are really seeing that * 2 = 760Mbit of throughput. 380 in, 380 out.
It wasn't in and out simultaneously, one direction only with Iperf.
The singlecore Atom of the Desktop had no problem with 670MBit, I think the PCI bus of the Gb NIC was the limitation there when it was directly hooked up to my laptop.
Laptop has a T7600 + an expresscard Gb NIC, so no limitations there I guess. -
If the desktop and laptop were on different interfaces of pfSense, then you were still getting 380 in and 380 out, they were just on different NICs.
Desktop -> nic1 | pfsense | nic2 -> Laptop
A 380Mbit transfer from Desktop to Laptop is 380 in nic1, 380 out nic2, 760Mbit total traffic being handled at the router.
As for the NetBIOS traffic, that's up to you if you want it allowed. That's really just local broadcast traffic to its own subnet, it doesn't hurt anything on pfSense and isn't trying to route out to the Internet.
-
They where, the desktop on the wan NIC and the laptop on the lan NIC, so 380Mbit is the maximum?
I think that will do for the next couple of years, till ISP's go further than that :PHmm, okay.
Now I only have to figure out why "halt system" isn't always able to completely shutdown the system.
Most of the time it works, but sometimes I have to hold the powerbutton to have it turn off completely.
But that's not really an issue though, since it will be up 24/7 soon. -
It may be the maximum for that particular set of hardware.
As for the power-off deal, that sounds like what could be an ACPI BIOS issue.
I saw that once or twice on an Atom system I had here but could never reproduce it. As you said, they were intended to be up 24/7 so it wasn't a big deal to figure that one out.
-
Okay.
Well, if/when upgrading becomes necessary, maybe pfsense will be supporting* dualcore cpu's by then?
(*Vaguely remember reading somewhere it doesn't, but could be wrong.)That's what I thought, but most of the time the shutdown goes normally, so why every now and then it doesn't…
-
pfSense has supported dual core CPUs for some time. The OS just sees it as two processors. When doing a full install, make sure you select the "Symmetric Multiprocessing Kernel" (SMP) and it will use all detected cores, and if you have hyperthreading enabled, it will show cores*2 CPUs. (It showed 4 on my Atom 330 until I disabled hyperthreading)
-
Hmm, okay. :)
