2.0 Site to site, routing issue?

[skorge]

Sure,

This is from the client. Server looks the same but with 1194 UDP on WAN as well.

[jimp]

Check your setup against this:

http://doc.pfsense.org/index.php/OpenVPN_Site-to-Site_PKI_%28SSL%29

[skorge]

Thanks jimp,

I've been going through that guide around 150 times by now and I believe I have configured it exactly the same. Feels like there is no routing between LAN and OpenVPN interfaces..?

[jimp]

Using multi-wan or other policy routing by chance?

If so, the traffic is probably hitting a rule with a gateway and getting shoved out a WAN instead of following the firewall's routing table.

Add a rule at the top of the list with a destination of the VPN network(s) that has no gateway set.

EDIT: I didn't see your attachment there earlier, so I see you aren't. Though checking the system's routing table on both sites is a good idea.

[skorge]

Thanks,

I think the routing tables looks fine. The attached is from the client, and the server looks the same (but reverse of course :) )

[skorge]

Could this be related to iroutes?

[jimp]

If you don't have iroutes setup (or setup properly) then yes it can be related to iroutes.

[skorge]

i do have an iroute on the server with just the CN of the client and the following line:

iroute 192.168.10.0 255.255.255.0;

[jimp]

You might be hitting this:

http://redmine.pfsense.org/issues/1417

Try adding this to your custom options:

client-config-dir /var/etc/openvpn-csc;

[skorge]

Yes, that was probably it. Thanks!

I think I have some other problems with my configuration but it looks much better now!

Thanks a lot for your help.

[skorge]

Packet captures tells me everything works fine on the server side, but remote side doesn't route between openvpn and lan interface if source is from behind server…

Do I need iroutes on the client side as well?

[jimp]

No, iroutes only go on the server side. Clients just have route statements. Servers need both route and iroute. Check the doc wiki, search for iroute, there is a troubleshooting doc.

[skorge]

Thats what i thought.

Checked the docs and I have it set up exacly like described. Acts just like the iroute problem on the server though.

I had to set mode server; could that cause these types of problems?

[jimp]

I think I've got this sorted for sure, it works for me in a Peer-to-Peer (SSL/TLS) setup with iroutes between two VM networks.

https://rcs.pfsense.org/projects/pfsense/repos/mainline/commits/0cc5ab42269a5aa1588ac2f862b0201917569ada

Either try that change or wait for the next new snapshot and then try it again.

[skorge]

Had to wait a while to be able to upgrade the remote side, but I am happy to say that it is working just fine after updating to the latest snapshot on both sides.

Thanks for your help jimp!