Port forwarding issue

kirlox_kitoy

I am having an issue forwarding Port 2020 I dont know why, could anyone please enlighten me, also is it possible to port forward like this
NAT?

WAN 192.168.10.2–--->22
WAN 192.168.10.5----->22

GruensFroeschli

You don't say what your issue is…
Yes you can forward from multiple VIPs to the same server.

kirlox_kitoy

Can you please enlighten me how to DO it,The situation is like this I have two workstations and they both have ssh, I want to be able to ssh both using the same wan address on the outside is it possible?

_igor_

You have to create a portforwarding (NAT) for every single destination-IP, say
port 2020 -> 192.168.10.2 and
port 2021 -> 192.168.10.5

Only fill the red marked entries and youre done. If you have problems reaching the local hosts, try enabling/disabling "NAT reflection" or set this systemwide at "Disable NAT Reflection for port forwards" under "System" - "Advanced" - "Firewall/NAT".

With some special cases you have to put "Filter rule association" to "pass" instead of allowing to create a separate rule.

Hope that helps you out.

mcrook

Umm what do you do when your pfsense is being a crap box instead of a firewall and won't pass anything you setup?

here is my setup

WTF is happening? it should be good to go?

fw_rules.jpg_thumb

Metu69salemi

Then you start over and think what you want to achieve ;)

Can you take your last added rule from wan side. and create port forward as previously mentioned?