Tp-link tl-wn321g v4 usb wireless adaptor problem
-
hello
pfsense supports the thinking of the USB wireless adapter I bought tplink tl-wn321g v4.
problem is the following:
during the first boot pfsense does not recognize the usb adapter.
ugen4.2: <ralink>at usbus4
run0: <1.0> on usbus4
Root mount waiting for: usbus4
run0: MAC/BBP RT3070 (rev 0x0201), RF RT2020 (MIMO 1T1R), address 74:ea:3a:95:2b:4e
runfw: root not mounted yet, no way to load image
run0: failed loadfirmware of file runfw
run0: could not load 8051 microcode
device_attach: run0 attach returned 6
run0: <1.0> on usbus4
run0: MAC/BBP RT3070 (rev 0x0201), RF RT2020 (MIMO 1T1R), address 74:ea:3a:95:2b:4e
runfw: root not mounted yet, no way to load image
run0: failed loadfirmware of file runfw
run0: could not load 8051 microcode
device_attach: run0 attach returned 6
Trying to mount root from ufs:/dev/ad0s1aAfter the boot process, see the device when inserting the device off the back.
run0: <1.0> on usbus4
run0: MAC/BBP RT3070 (rev 0x0201), RF RT2020 (MIMO 1T1R), address 74:ea:3a:95:2b:4e
run0: firmware RT2870 loadedpfsense every boot when I'm having this problem.
I think there are drivers but could not figure out the problem. Is it possible to install pfsense to the driver?
pfsense 2.0 rc1
tl-wn321g tplink v4 (Ralink rt2020 or rt 3070)I wish you good day</ralink>
-
Add the line
runfw_load="YES"
to /boot/loader.conf.local to get the firmware loaded at boot time.
-
Thank you.
The first problem is solved at the time of the boot.
ip to the modem but can not ignore this time. I use the product as a wan.
installed pfsense will do again.
I do not understand there's a problem. realtek modem chip product is the same rope. tp-link does not.
-
kankabir, did you ever get this issue resolved?