Webgui on opt2

mphilli7823

All,

I have created an additional interface (opt2). How do you enable the webgui on that alternate interface?

mikeisfly

Not sure what you mean here? However when ever you create an interface (opt2) you than have to create a rule allowing traffic to leave that interface. You can do that in the rules section. Make sure that you go to services and then DHCP and configure that if you would like host to be assigned address dynamically. As long as your rules don't forbid it, the web gui should be accessible from there.

mphilli7823

I created an interface on opt2 and I want to be able to access the webgui on that interface. However I am unable to access the webgui on it. Is that possible?

Supermule

Yes

Trel

@mphilli7823:

I created an interface on opt2 and I want to be able to access the webgui on that interface. However I am unable to access the webgui on it. Is that possible?

Have you written a rule that allows this to happen?

Gertjan

First:
@mphilli7823:

…..
I want to be able to access the webgui on that interface.

Then:
@mphilli7823:

However I am unable to access the webgui on it. Is that possible?

Come again ?!

Trel

It sounds like he made the opt2 interface, but didn't right rules that would allow him to access it as it wouldn't be affected by the anti-lockout rule LAN has.