Amazon Fire TV not working
-
OK, testet it now, and it's not working :(.
Why is it only working for a few minutes after checking "Disable all packet filtering." in the advanced firewall/nat and uncheck it again? Don't know whats happening there. The firewall logs alsways says the same and allowing the traffic.
-
Im not sure. I suspect its something particular to your configuration. You have several things configured on that router.
Are you blocking ANYTHING on the LAN?
Do you have a good allow-all rule?
When you "Disable packet filtering" you are turning off the firewall.
At that point it establishes a connection and works.
The connection once open is persistent even after firewall is enabled again.
Until it eventually dies sometime later.
So I'm wondering which rule is killing it?
-
Can you post your lan firewall rules?
-
The strange thing is, if I check the disable all packet filtering to disable the firewall, every client will lost his connection. So nobody can access anything anymore. After unchecking it, everything works fine.
Here are my LAN rules right now:
http://imgur.com/Cv99Fkd
That's the allow all rule:
http://imgur.com/ncDxZ1m
These are the UDP ports opend if it is working:
http://imgur.com/rxeaChx
EDIT: hm, now it's not working anymore and the UDP connections still are established.
-
It's getting even stranger, if I try to watch a movie, sometimes it takes some minutes, but then it starts. So it seems to be very slow, but works?! :-[
EDIT: yes, if I can click to watch a trailer or film, it works now. But the menue dont works, and gets me errors. But after disable and reenable the firewall, also the menu works fast and fine.
-
Looks like you got carried away with your firewall rule set.
Looks abit over complicated.
I'm pretty sure this is a self inflicted issue.
-
Maybe there is a problem in the NAT configuration? I ask myself why everything works, also TV's but not the FireTV in the menu. The menu is too slow, but streaming works well if I get the chance to see the "play" button.
-
OK, I deleted all my Firewall Rules, all my NAT forwards and outbounds, but it still don't works.
Now I made a factory default reset and it works! But why the hell, what is different? -
OMG, think I got it ;D. On WAN interface was a manual (wrong) MTU set, after deleting it works till now with my old config!
-
I'm glad its all good now. (-:
So nothing special required. Thats actually good news.
-
Yes, it is :)