Cannot synchronize firewall rules, objects… in cluster
-
Hello,
Nice to meet you.
During my cluster setup, the failover test worked well but it couldn't synchronize firewall rules, objects…
According to below error message, would you please instruct me how I should deal with the issue?
Thank you very much.[ An error code was received while attempting XMLRPC sync with username admin http://33.33.33.31:80 - Code 6: The requested method didnt return an XML_RPC_Response object.]
-
You have to add a rule add both masters and backups sync interface to allow the packets. If thea are separate interfaces just allow any:any to any:any.
Ensure that you choice at Protocol pfsync or any. -
You have to add a rule add both masters and backups sync interface to allow the packets. If thea are separate interfaces just allow any:any to any:any.
Ensure that you choice at Protocol pfsync or any.Thanks. I added firewall rules in Sync Interface as attached figure with both pfsync and Any rule. But it could not sync rules, objects…
Any other possibilities?Thank you.
-
Up , I have the same error :'(
-
OP- Are both of your webgui's running on port 80?? Please read the HA Sync page carefully. If you are really running the webgui on 80, verify the password is correct, and try re-entering it.
tiflao- It's the exact same error? Generally, you should start your own thread instead of adding a me too. Can both boxes ping each other from the sync interfaces? Both are running the gui on the same port? Allow all on the sync interface? Triple checked the password was correct?