LightSquid report configuration (User RealName)

KOM

I'm not even sure it would know the user unless you're using some type of authentication to allow access to the proxy. Without that, I suspect the best you can do is an IP address or resolved DNS name.

noriel

@KOM:

I'm not even sure it would know the user unless you're using some type of authentication to allow access to the proxy. Without that, I suspect the best you can do is an IP address or resolved DNS name.

I have captive portal enabled sir…

KOM

OK, so in Lightsquid config, have you tried the alternate IP Resolve methods like Demo or Simple or Squidauth?

noriel

I found something here http://lightsquid.sourceforge.net/How%20It%20Work.html

but I dont know where to enter those commands

KOM

OK, so in Lightsquid config, have you tried the alternate IP Resolve methods like Demo or Simple or Squidauth?

noriel

@KOM:

OK, so in Lightsquid config, have you tried the alternate IP Resolve methods like Demo or Simple or Squidauth?

Yes I tried. Nothing change

KOM

It doesn't change any historical data, so you would have to make the change and then wait and run a new report. I don't know if this works as I don't have a captive portal. Just thinking up suggestions.

noriel

i found a way..solved already.. Thanks a lot

doktornotor

@noriel:

i found a way..solved already..

That is immensely useful to everyone else here… NOT! ::) >:(

Guest

@noriel:

i found a way..solved already.. Thanks a lot

Would you be nice and share your result(s) with us all, because it could be also interesting
for us too? An forum is living from those entries and fixed or solved out problems by naming
or showing a dedicated method.

noriel

@noriel:

i found a way..solved already.. Thanks a lot

I didn't post the solution YET because Im currently testing it on my setup..and it sometimes work sometimes not..that't why… I always love to share my solutions,my way of giving back and saying thanks to the community... I can prove that...

anyway, I'm trying the method and instructions from this link http://lightsquid.sourceforge.net/How%20It%20Work.html

I'll post the guide here or how I did it once I tested that it really works. Thanks