Ntopng - not showing up under diagnostics
-
I am new to pFSense and I just received the SG-2440 appliance. I installed ntopng and I don't see it showing up under the diagnostics section. How do I got about accessing the GUI ?
-
Re-install it again.
P.S. A reworked package that hopefully won't fail and screw settings on every other install is here: https://github.com/pfsense/pfsense-packages/pull/1064
-
tried re-installing the package and jus the web GUI and no luck
-
Yeah. So wait for a working package.
-
I got it finally, I am new to pfSense and I think I was navigating away from the package installer screen while it was installing. I though it conitued on in the back ground…. oopps
its there now
-
Oooops. Yeah, never do that. It's not background operation.
-
THANKS ! now you tell me !! hahaha No problem.
I appreciate the comments and help. its all working now. do i need NTOP for NTOPNG to work ? Or should i just remove NTOP ?
-
No, you definitely do not need ntop.
-
I have installed NTOPNG, and occasionally use it for monitoring traffic. I opt to disable its service by unticking Check this to enable ntopng, but the service starts when my pfsense box reboots. Any though on this?
-
I have installed NTOPNG, and occasionally use it for monitoring traffic. I opt to disable its service by unticking Check this to enable ntopng, but the service starts when my pfsense box reboots. Any though on this?
Are you going to post this to couple more threads as well? https://forum.pfsense.org/index.php?topic=101841.msg568022#msg568022
https://github.com/pfsense/pfsense-packages/pull/1142
-
Thanks for all the help, since its working I will go ahead and lock this topic
For everyone else, the reason it didn't show up I didn't stay on the screen when the package was isntalling. Once I left the package re-install I had no problem accessing