Traffic being blocked despite rules allowing
-
I have a pfSense 1.2RC2 box in a bridge mode with LAN & WAN.
If I UNTICK the "enable filtering bridge" mode in Advanced settings, then traffic can pass.
However, if I TICK that option AND allow all traffic in a rule in the LAN then nothing passes.
However, the traffic logs are showing the ping attemps, with a green arrow in the "Act" column, implying that they should be passing….but they're not.
It works fine on an LAN & OPT1 interface, but not if I bridge the LAN & WAN. Anyone any ideas?
[edit - spelling]
-
Nailed it.
NATting on the WAN interface is enabled by default. Switch NAT off (and remember to apply the changes because I did try switching NAT of earlier, but hadn't realised I hadn't applied it)
God, I've spent ages trying to figure out why that was!