Lightsquid on pfSense 2.3 - Error with report folder?
-
Also make sure you use ctrl-F5 in the browser when reloading the lighttpd pages, they cache like crazy.
If you had a crash report waiting on the dashboard, you'd know it, it would be showing in a bar at the top of the page.
-
Ok, so there is no error on the top page.
I tried with Chrome instead of Safari but this does not change anything so I this should not be a browser problem.
When I refresh the lighttpd pages with ctrl+f5 it does not change anything, too.
-
Little update in my case:
As I found out the "Refresh Scheduler" that I have set is working without problems. The data of Lighttdp updated according to the time period I have set.
So only the "manual" refresh with the buttons provided is not working for me.
-
thanks for pinning down the problem.
I am on a fresh install, and had exactly the same problem. I reported it in the wrong forum (general discussion).
update:
the shell command works for me as well. but not the WUI buttons.
-
thanks for pinning down the problem.
I am on a fresh install, and had exactly the same problem. I reported it in the wrong forum (general discussion).
update:
the shell command works for me as well. but not the WUI buttons.
Same for me.
-
[SOLVED] pkg install -f perl5
In my case, I have blank page on Lightsquid report page aftter pfsense 2.3 update. I´ve tried uninstall lightsquid troubleshooting procedures https://doc.pfsense.org/index.php/Lightsquid_Troubleshooting but nothing, lightparser.pl show lib error.
/usr/local/bin/perl5 /usr/local/www/lightsquid/lightparser.pl
Shared object "libperl.so.5.20" not found, required by "perl5" -
I fix it the same problem with command prompt
/usr/local/bin/perl /usr/local/www/lightsquid/lightparser.pl
-
I found a problem with the refresh buttons, a new version with the fix should be out sometime today.
-
OK. I install update version.
But what are the correction?Squid RealTime stat always don't working
-
It was exactly as I stated: The lightsquid update fixed a problem with the Refresh and Refresh Full buttons not working. Squid real time is not a lightsquid issue. That belongs in another thread.
-
I fix it the same problem with command prompt
/usr/local/bin/perl /usr/local/www/lightsquid/lightparser.pl
When I try this command I receive an error command not found. There is no perl in /usr/local/bin only perl5 and if I execute
/usr/local/bin/perl /usr/local/www/lightsquid/lightparser.pl
Shared object "libperl.so.5.20" not found, required by "perl5" -
@jimp, thank you for fixing the problem that quick!
