PfSense version numbers
-
I'm not recommending this. But if the system is not critical and you want to experiment. You might gitsync it to RELENG_2_3_3.
playback gitsync --minimal --diff --show-files --dry-run git://github.com/pfsense/pfsense.git RELENG_2_3_3Remove the dry-run option when you want to actually apply the changes.
Oh that's option 12 on the console. Also reboot after applying a gitsync.
Also note RELENG_2_3_3 went from RC to RELEASE this morning.
-
:-\ will try that when I feel brave enough!!!
Seriously, it's a VM (kvm) so, I can happily try that and restore from a backup if it fails!!! 8)
Thanks for your help and advice!
-
So, that brings me back to how I ended on 2.3.4….. :o
ok, if I just "wait" for 2.3.4 this should be fixed by then or you recommed to backup, reinstall and restore ?Because your updates were tracking RELENG_2_3. Which previously was 2.3.3 Development.
When 2.3.3 went to RC. A new branch for it, RELENG_2_3_3 was made from RELENG_2_3, and the RELENG_2_3 branch went to 2.3.4 development.
Since you where tracking RELENG_2_3 branch you went to 2.3.4 development along with it.
I don't think there is any reason to reinstall if your update setting is set to now track stable I don't think you'll get anymore updates from RELENG_2_3 (2.3.4 development). Your just a few commits ahead of RELENG_2_3_3 (2.3.3 release).
If you want to get back from being ahead. I think a gitsync would do it. But I don't know for sure and thus am not making this a recommendation.
-
If you have VM snapshot form 2/10 (or before) it will probably be of 2.3.3. You could go back to there and change the update setting to track stable.
-
If you have VM snapshot form 2/10 (or before) it will probably be of 2.3.3. You could go back to there and change the update setting to track stable.
The oldest snapshot I have is from 2/10 so I will try that al see what happens.
Thanks again!
-
Went back to 2/10 VM snapshop, switched to STABLE, upgraded from console and now I'm on 2.3.3-RC
Thanks!!!
-
Hi guys,
I had the same problem where I was running 2.3.4. I ran the gitsync command a from an earlier post & now the system reports 2.3.3 in the version box I still show:
Current Base System 2.3.4.a.20170227.0254
When I check for updates.
Is there a file I can edit to correct this?
-Will
-
Hi,
I got this one today :)
-
https://forum.pfsense.org/index.php?topic=126523.msg699285#msg699285
-
https://forum.pfsense.org/index.php?topic=126523.msg699285#msg699285
Thank you very much :)
