Traffic Graph Problem
-
I have two identical hardware with pfsense 2.3.4-RELEASE installed on them but acts differently when showing the traffic graphs.
The one that has no problems, upon going to Status -> Traffic Graph, populates the graph starting from the rightmost side and plots the data points. Hovering the mouse pointer over to the initial data points gives me an accurate measurement of the X and Y values (you see the vertical line dark blue circle snaps in to the actual data points while I move the mouse from left to right or vice versa).
The one that has issues populates the graph starting from the center and when I hover the mouse pointer over to the initial data points, it gives me a 0.00Bps result and the blue circle doesn't snap in to the actual data point that was plotted in the graph. What I have to do is to wait for the graph to fully populate from center to right and then that's where I can see the expected results.
Any thoughts on this?
-
BUMP!