HAproxy 1.8.0

maverick_slo

Sure :)
Well .3 is quite OK, at least for me.
You know that one: https://i.imgur.com/HTisMpC.jpg :)

PiBa

Ok 1.8.3 got pulled in :) including a few webgui improvements.. Give it a try.?

maverick_slo

Hi!

Thanks!

Installed it, working just fine.
Trying to configure http/2 for my exchange 2016 on server 2016… It does not work yet, I think it was mentioned somwhere that haproxy can`t deal with http/2 backend just yet?

PiBa

I think your right about that h2 on frontend only for the moment.

maverick_slo

1.8.4 full of bugfixes :)
Finally, this one should be really stable :)

maverick_slo

1.8.5 :)

PiBa

Agreed :), 1.8.5 should be really really stable ;)

Give me a few days ill try and get that in.

maverick_slo

Sure thanks!

Will try it out :)

PiBa

Well 1.8.6 will likely be out in a week or so, 1.8.5 has some little buggers.. lets wait for that..

maverick_slo

You were correct. 1.8.6 is out :)

PiBa

And now 'haproxy-1.8.7' has just arrived upstream.. Now i expect/hope it will stick to that for a while.

PiBa

Okay 0.56 haproxy-devel package with 1.8.7 is available now through normal pfSense packages.

maverick_slo

Thanks it works
2 deploys around 40 websites…

maverick_slo

Hi PiBa!

I have weird situation since upgrade…
Haproxy hits 100% cpu usage on 2 specific backends.
One is qbittorrent and other Nextcloud. Page loads partially and after a minute or so page is fully loaded and haproxy usage goes to normal.
Other backends have no such issue.
Any idea from top of the head?

Thanks!

Capture.PNG_thumb

PiBa

Not really any good ideas a.t.m. struggling with a other issue myself where a page using NTLM authentication just fails to load at all.. For me the 'workaround' of using the option 'nokqueue' in global settings fixes that issue. Can you try that? Though kqueue 'should' perform better.. Can you report back if that indeed 'fixes' it?

maverick_slo

Hi!

Thanks, that fixed it completley!
Whats up with that?

Capture.PNG_thumb

PiBa

Somehow the kqueue poller code is 'broken' in apparently several ways.. I'm trying to get Willy (or anyone with proper C++ coding knowledge) to take a look at it :) (check mailing-list of haproxy there are some mails of me past few days). But its a 'work in progress' at the moment.

PiBa

Okay 1.8.8 is released and available 8). Can you try it out without the nokqueue setting ?

maverick_slo

Sure thing will update and test tomorrow morning.
Seen the changelog, thanks!

maverick_slo

Hi again!

It`s working as expected now :) Pages load no more partial loads.