UDP Rule not working
-
I have setup a UDP rule to pass all packets for port 1024 - 65000
But my Firewall Logs so that they are still being blocked what must I check for?
-
What are you trying to make work?
Also, post the WHOLE rule set.
Do you have any block rules above the pass rule?
Do you have any floating rules?
Did you put the rule on the correct interface?
Are you trying to NAT? -
Hi almabes here is more information
I have a box with 3 NIC, 2 are in bridge mode for transparent filtering here are the screenshots
Lan is for my Admin Access [Lan IP Address]
PublicIP is connected to the Provider Router [No IP address]
PBXIP is connected to my server [No IP Address]
-
I am not an expert on bridging in pfSense. I haven't implemented it at any customer location.
You also didn't post ANY of the information I asked for.
No full rule set.
I assume you are not trying to NAT since you're using a transparent mode firewall in a bridge.
-
SOLVED! Solution is as simple and the right order of rules.
-
SOLVED! Solution is as simple and the right order of rules.
…which we probably could have told you about sooner if you would have posted your rules as requested. Oh well, at least it's working for you.
-
What are you trying to make work?
Also, post the WHOLE rule set.
Do you have any block rules above the pass rule?
Do you have any floating rules?
Did you put the rule on the correct interface?
Are you trying to NAT?I am new here please help show me how I post "WHOLE" rule set…
-
I am new here please help show me how I post "WHOLE" rule set…
By taking a screencap that shows all the rules and not just some of them.
