Help with my PIA OpenVPN setup
-
Hello Everybody (and apologies in advance if I am posting in the wrong place),
I currently am using pfsense as a virtual router for an esxi environment.
I currently have three interfaces attached to the pfsense VM. One that is WAN, One that is my Main LAN, and one that I want to be a secondary LAN that routes all traffic through Private internet access via Open VPN with a kill switch should the VPN go down.
I can't seem to get it right though. Either everything goes through the VPN or I don't have internet access, and until I get it working I won't start trying to configure the kill switch part.
Any help anyone can give me would be greatly appreciated. I am happy to provide any details about my config anyone might need to point me in the right direction.
Again thanks in advance,
Tiff -
Enable Don't pull routes in OpenVPN.
-
Here are screen caps of all my settings I am not sure what you are recommending I change.
![interfacewan1.PNG](/assets/up loads/files/1565551542468-interfacewan1.png)
-
In the OpenVPN client settings:-
I bet if you were to look at Diagnostics -> Routes the default route is pointing to the VPN