NTP GPS Settings : serial port speed.
-
i have also took a look at the generated ntpd.conf, and it was ok, on my pfsense 2.5.0 ntpd is launched with mode 16 (9600 bps),
your init command was also good,
$PUBX,41,1,0007,0003,9600,0*10maybe it needed a reboot
-
Many reboots and system halts this week and all had no effect.
-
I took my current running 2.5.0.a.20200214.1446 version that could change serial speeds and change the NEMA sentences and updated to the latest 2.5.0.a.20200409.0657 version. Now the serial port always runs at 4800 and the NEMA sentences will not change either.
-
@n8it said in NTP GPS Settings : serial port speed.:
I took my current running 2.5.0.a.20200214.1446 version that could change serial speeds and change the NEMA sentences and updated to the latest 2.5.0.a.20200409.0657 version. Now the serial port always runs at 4800 and the NEMA sentences will not change either.
Please show gps config part
-
I get the message "Post content was flagged as spam by Akismet.com" when I tried to reply with the gps config.
-
The config file is being updated, but the port speed is not changed from 4800 baud with 2.5.0.a.20200415.0942. All works fine with 2.5.0.a.20200212.1057. If someone can provide the link to the pfsense release right before and after the last NTP update I will try those.
-
@n8it
try again to post the ntpd config, you should be able to now -
it is like you said, i can't change speed on my 2.5.0, it revert back to 4800.
@viktor_g
$gpsbaud is always reporting 4800 for me on system.inc
also the gui revert back to 4800 even if i set the speed to 9600 -
Fix: https://redmine.pfsense.org/issues/7284#note-5
You can apply patch or wait for the new 2.5 build
-
you are too fast man
it work
[2.5.0-DEVELOPMENT][root@pfSense.kiokoman.home]/dev: stty -f gps0 speed 9600 baud;
