Solved!! pfsense vlan untagged interfaces with vlans on same trunk
-
I had to add a static route to be able to access my switch management from my wifi side. is the routes on my switch causing the issue then maybe?
-
Well your doing it wrong from the get go then.
Are you wanting to do routing on your switch, or just layer 2 - or a combination?
-
pfsense is going to do all the routing. I just need to have one static route because otherwise my phone (192.168.1.20) cant access my switch management at (10.0.0.2)
-
Only route you would need on your switch is the default route, pointing to pfsense Ip in whatever vlan you put your management IP in.. Then you can get to it from any other network routed by pfsense.
As you can see on mine.
ip default-gateway 192.168.9.253That is the setup on my switch. Its management IP is 192.168.9.99
! interface vlan 9 name lan ip address 192.168.9.99 255.255.255.0 -
ok so i setup the route and the interface as it should be and but the ip address for the vlan interface which im using dhcp for is getting its address unless I put my pfsense vlan tags on another interface. Im using 2.4.5 and is that maybe the problem?
-
Using 2.4.5 not sure why you think that would be a problem..
You can use dhcp if you want, not sure why anyone would do that on a switch management IP - but sure you can do that.
If using dhcp it should prob get its gateway from dhcp I would think..
from your config for your trunk port I don't see anywhere you set which vlan is untagged.. Not sure how you would do that on a hp switch.. But in cisco setting it to native as you saw in my config tells the switch what vlan to put untagged traffic in, and what vlan to send egress from the port untagged. It sets the pvid on the port so any untagged traffic ingress is in that vlan.
-
so it tells me 1(default) 10, 99-100 as interfaces with a pvid of 1 and passing all vlans correctly.
-
Well yeah vlan 1 is default untagged vlan.. So that would work..
-
it doesnt work with another switch I have and its the exact same configuration. untagged on one and then tagged on 10,99,100. what version of pfsense are you using?
-
Its not rocket science traffic is either tagged or not tagged.. If just naked on the interface directly its untagged. If it's setup as a vlan then it will have whatever vlan ID tag you put on it..
So here is my interface where I put my vlans and native untagged traffic. so igb2 network is 192.168.2/24, vlan 4 and 6 are 192.168.4/24 and 192.168.6/24
On the switch this untagged is vlan 2.. Makes it easy to know what vlan is what when the ID is just the 3rd octet of the network address space.
-
i checked that and made sure mine matched. what I did find out though is that my lan port (em0) if I change it to my 2nd interface (em2) that it works exactly how I expect it to. I wonder if its a bug and its already assigned that it causes that issue. it is the lowest mac address too so maybe that was my problem
