TLS Encryption and Authentication not working. Authentication only, working fine
-
@johnpoz The[0_1608162720468_OpenVPN.config.pdf](Uploading 100%) config
-
And what is not working? What does the log say on connection? Your not using encryption there your using just auth.
Your not even using tls there.. And what are you using for auth? One sec an will post up mine
here
-
@johnpoz This is normally working. The problem is that when I set TLS Authentication to TLS Encryption and Authentication I don't get a connection anymore.
-
Your not using TLS.. so how would it encrypt.. You just have user auth set, not remote (ssl/tls)
-
@johnpoz You are right. Let me check again. I did that as well and also did not work, but I changed several other settings at the same time (stupid) and I had set it back to just the auth setting and now I forgot to enable SSL/TLS again.
-
@johnpoz Now I remember: In that case I could not create a new cert. Instead I got the message "If a client is missing from the list it is likely due to a CA mismatch between the OpnVPN server instance and the client certificate"
JohnPoz, I appreciate your help quite a lot, but here (Amsterdam) it is 1.30 am and I have to get up early tomorrow morning.
Tomorrow I will focus on that. Hope I can solve it then.
-
The wizard walks you through creating a CA and server cert.
Then just create a user cert from that CA.
-
@johnpoz I have been focusing on the wrong subject all the time. At a certain point you get too tired trying to solve a problem that you lose oversight. I had several certs for testing and probably used the wrong one. I will change that tomorrow and I am convinced that that probably is the problem.
Thanks a lot with your help and I will let you know if this indeed was the problem.
Have a nice day.
-
@maartenv : before redo your VPN setup : take the Youtube -> Netgate -> OpenVPN videos.
Zeker weten dat je al je vragen beantwoordt krijgt ;) -
@gertjan Dank je voor de tip, probleem is inmiddels opgelost
-
@maartenv Thanks for your help. Problem is solved now.
-
En de winnaar was.....
-
@pippin After I had changed the Local Port Number in a new Wizard run, the new port number was added to the WAN firewall rules.
When I was cleaning that up, by accident I removed the wrong port number.
And then you can do whatever you want, but you will never get it working
