Site to Site Wireguard not routing over tunnel
-
Hello everyone.
I have followed the documentation for a site to site configuration. Everything is ok up to the point i have the gateway creation and interface adding. After i have put firewall rules wide open on the interface, i go diagnostics->ping from site1 Lan to the pfsense of site2 lan. No ping.
I saw default Lan rule was from: Lan net, so i changed both firewalls to any. I thought that this is it... But no. Still no route through the tunnel.
Anyone tried the site to site?
What might be wrong? Is it still on beta version? -
There isn't enough information to speculate about what is happening there. If it isn't routing LAN-to-LAN, then it could be pretty much anything. You need to supply more detail about your specific configuration in WireGuard, firewall rules, and routing on both sides.
-
@jimp Hello Sir.
I have sort out all issues and now i have more specific questions.(Working now).I have added a rule on Wan interface, destination wan address for the port used on both sites. Is this necessary to both ? (1 site has static public ip, the peer is dynamic)
I have a rule on both sites Lan's: source * (any) instead of Lan net. Does this needed ?
I have allow all rule on WireGuard auto created tab and also on the Wireguard virtual interface i have made the assignment. Does those rules both needed ?
Thank you , your comments are much appreciated.
