How to Restart OpenVPN Wizard from Start/Scratch
-
Every time I go into the OpenVPN wizard it picks up where I left off the last time. For example, it continues on step 6 of 11. I need to reset the wizard from scratch. I have tried restoring to a previous configuration, I have of course restarted the unit, etc but I do NOT want to finish the wizard as I have incorrect selections. How can I reset the wizard? I am running 2.4.5-RELEASE-p1, FreeBSD 11.3-STABLE
-
Step 6 of 11 (Certificate Authority Selection) is the default after selecting Local User Access as Backend Type.
You can edit any setting after the wizard is finished in VPN > OpenVPN > Servers > Edit Server anyway.-Rico
-
I appreciate the fact that I can change the settings later but I would like to know how to completely reset the wizard so it starts from the beginning again. I find that any of the wizards always retain what was previously selected and/or previously completed. It would be good to reset it to start from the beginning, there should be an option to do this?
-
Just run through it.. Then delete the instance if you don't want it. And start the wizard again and it will start from step 1.
-
@johnpoz Same issue as kbiker2011. I followed your advice to run through the wizard and I went back and deleted any reference to OpenVPN, certs, cert server, etc. Once I restart the wizard I choose 'Local User Access" --> NEXT --> It continues from step 6.
If a CA is defined it will restart at step 5.
How do we fully reset this so it starts back on step 1 or shows what is/was included in steps 1-5, etc.
EDIT:
I tried this on a fresh install of v2.5.0 in a VM and it starts at step 6. Nothing else is configured. Am I missing something here??? -
@patg_84
it's normal, step 2/3 is to configure LDAP
step 4/5 is to configure RADIUS
if you select "local user access" you jump to step 6 -
@kiokoman Thank you for clarifying.