4 pfsense servers+vpn routing+vpn gui client

[viragomann]

@rostyslav-didus
Maybe the destination devices are blocking access from outside their local networks. This is the default behavior of PC firealls.

[KOM]

Dammit, clicked Delete by accident...

viragomann had a good suggestion above. Often times a desktop firewall will block traffic from outside its local subnet.

Can you not access anything on any network, or are you just trying Windows systems?

[Rostyslav Didus]

@kom I saw that message )
It is about vpn's config on each server.I'll add this info tomorrow.

[Rostyslav Didus]

@viragomann
I wish it was like this way.
But it is not.Windows FIrewall is turned off.
For some reason pfsense allows me to see only network behind the server I connected to.I'll add vpn config's of all servers tomorrow.
Thank you.

[viragomann]

@rostyslav-didus said in 4 pfsense servers+vpn routing+vpn gui client:

For some reason pfsense allows me to see only network behind the server I connected to.

From your first post, I assumed you get not even this.

So you connect to different servers by vpn and want to access the remote networks in the other locations, which are connected with a site2site?

[Rostyslav Didus]

@viragomann
Yes.Correct.

[viragomann]

@rostyslav-didus
So consider that you have to populate the route for the access servers tunnel network on the s2s remote sites.

[Rostyslav Didus]

@viragomann
Server side

Vpn server settings for users with openvpn gui client.
As you see,I entered all subnets to ipv4 local networks.
Should I add here tunnel network subnets?

Client side+server side for tunnel 1

Client side+server side for tunnel 2

Client side+server side for tunnel 3

When I connect via openvpn gui and trying tracert command to 10.10.104.2(windows server) I receive time out.

If I try to connect to any subnet's server it works fine when I initialize connection from one of those subnet(10.10.100.0/23,10.10.98.0/23 etc.)

[viragomann]

@rostyslav-didus
You have to add the access server tunnel network 10.1.5.0/24 to the "Remote networks" on all remote sites, so that the branch routers set a route for it pointing to the main.

[Rostyslav Didus]

@viragomann,
My Lord!
It works now.Added 10.1.5.0/24 to each "remote networks" configuration.
I appreciate that.
Thanks a lot.