FRR peer status active

[Joe_F]

As far as I can tell I have configured frr correctly within pfsense doing everything as I can see it in the video and documentation (for ipv6 not 4) but it doesn't even seem to try and connect to my neighbour/peer just sitting at active. I have gone through everything several times but just cannot see where I am going wrong.

For address family: IPv6 Unicast
  Not part of any update group
  Community attribute sent to this neighbor(large)
  Default information originate, default not sent
  0 accepted prefixes

  Connections established 0; dropped 0
  Last reset 00:00:05,  Waiting for NHT
BGP Connect Retry Timer in Seconds: 120
Next connect timer due in 116 seconds
Read thread: off  Write thread: off  FD used: -1

[rmymrtin]

@joe_f said in FRR peer status active:

n (for ipv6 not 4) but it doesn't even seem to try and connect to my neighbour/peer just sitting at active. I have gone through everything several times but just cannot see whe

Hi, i have a same problem ! I have the same error : "Waiting for NHT"