Firewall rules - Toggle enable/disable status



  • When I toggle the Firewall Rules enabled/disabled status, the appropriate action on the right is displayed but the toggle itself does not change visually. I believe the toggle shows the block/pass status only.

    In Firewall NAT the toggle shows the appropriate enable/disable action.

    Inconsistent gui for the same action was confusing to me at first but I figured it out.




  • LAYER 8 Global Moderator

    huh?  Can you post a picture of what your seeing?



  • In Firewall rules clicking the check mark on the left will toggle enabled/disabled status. The circle backslash action on the right is a hint that the rule is enabled.

    In Firewall NAT clicking the check mark on the left will toggle enabled/disabled status. The check mark will change to X when toggled.

    Try it.





  • LAYER 8 Global Moderator

    when I click rule in firewall to disable or enable it greys out if disabled and not greyed out if enabled

    When I toggle a nat it goes grey and x and or check blue check and not grey when enabled.  Your wanting the firewall rule to also show x when its disabled?

    I think the nat goes to X vs check to show you that its not natting or port forwarding.  While the firewall rule being disabled it still shown as green check to show allowed just not enabled.






  • It is just that I started with NAT changes first and I noticed the X when disabled. After, I worked on Rules and was looking for the X change. When it did not changed to X I was under the wrong impression that it did not toggle properly. It is all good now.


Log in to reply