4. SNMP reporting incorrect (double?) the bandwidth usage

SNMP reporting incorrect (double?) the bandwidth usage

  • A

    Hi,

    I've just set up a new SG-3100, and using SNMP sensors in PRTG to monitor various statistics, including bandwidth. The reported bandwidth in PRTG seems to be double the actual use - I'm seeing 20Mbps where it should be closer to 10Mbps (I wish it was 20!).

    I'm using a Multi-WAN setup, with policy-based routing, so I'm not doing anything fancy with load balancing etc. Both WAN links (WAN/mvneta2 and OPT1/mvneta0) seem to be exhibiting the same behaviour.

    The RRD charts in the device itself seem to be correct.

    Any thoughts?

    Thanks,
    -Alex

    0
  • L
    Netgate

    This issue was found after the release of 2.4.1 and it is already fixed for the 2.4.2.

    0
  • A

    Ah, ok thanks! I'll await the update then…

    -Alex

    0
 

© Copyright 2002 - 2018 Rubicon Communications, LLC | Privacy Policy