Pfsense + Clon PC + Virtual Box
-
Hello Guys,
Im new on this matters about pfsense hardware.
I want to install pfsense in the next scenario:
- Clon PC:
- 3 x Gigabit NICs ( TP-LINK TG-3468 Gigabit 10/100/1000Mbps, PCI-Express )
- Intel Core i3 Processor
- 8 GB RAM
- 128 SSDThe host operating system will be Windows 7, im planning to install virtual Box and then Pfsense on it.
I know this is more expensive than getting a Netgate product, but i already have the hardware i mentioned unused.
Also i want to know if using the NICs i mentioned would work, since im planning to use Two of them for WAN connection, and the other one for LAN.
Honest opinions about this idea?
Thanks !
-
Don't install Windows on it, don't use VirtualBox, also, just install pfSense directly.
Also: don't get the TG-3468. Don't get any of those. For the same price you can get a quad gigabit intel card.
-
pfsense will install on just about anything. Pfsense doesn't seem to have a particular preference. What u suggest will work. Doing your initial install on hardware u already own is a good starting point. Can always save config file, and restore it to a more dedicated box in the future if u like.
-
Running on what you've got already as a test is not a bad idea.
What's your reasoning for running pfSense virtualised? If it's because you have other VMs to run then almost anything else would be a better hypervisor!
If you need Windows 7 running natively (rather than that in a VM too) pfSense will run ok in virtual box.
Steve
-
Do you plan on using pfsense to protect the windows 7 client, or is it only to run the pfsense on virtual box? If only for pfsense, I would not recommend your setup. If windows 7 gets bsod, or exploit, your pfsense box is down.
If you need both, please look at a free esxi license. (Vmware)
Then run pfsense and windows as virtual clients.Else, most secure is to install the pfsense direct to the box.