FW rule and NAT rule to redirect all traffic from port 80/443 to 3128 (squid proxy) is not working.
-
Hello,
I have 3 interfaces on my pfsense 1 LAN and 2 for WAN (WAN1 and WAN2 respectively). I have installed squid proxy and squid guard packages to setup proxy. Which is running fine when I manually insert firewall ip and 3128 port number (which is default port for squid proxy). As per my setup I cannot use trasperant proxy setting nor WPAD. So, want to set firewall rules to divert all traffic form port 80/443 to 3128. But it is now working out for me.
I have added below rules under "Firewall > NAT > Port Forward"interface = LAN
source = any
source port = any
Destination = any
Destination port = 80
Redirect port = 192.168.10.1 (which is my firewall ip)
Redirect target port = 3128 (squid proxy port)And similar rule for 443 (HTTPS) port
I have also added rule under "Firewall > Rules > LAN"
Action = pass
Interface = LAN
Address = IPV4
Protocol = TCP/UDP
Source = Any
source port = any
Destination= This firewall (self)
Destination Port Range = 3128FYI, I am using pfsense version 2.4.3-RELEASE.
Thanks in advance to all
-
@ambrish did you make a proxy certificate from squid and import it into the firewall.
https://forum.netgate.com/topic/174070/squid-config-help-certificate-needed-issued-from-squid-proxy
