pfSense Netgate SG-1100 and Unifi UniFi Switch 24 POE-250W Not Working
-
Hi,
I followed instructions from here. How To Setup VLANS With pfsense & UniFI. Also how to build for firewall rules for VLANS in pfsese
My setup is VLAN70 on LAN.
Result:
No packets captured on pfSense Packet Capture on VLAN70 interface.
VLAN 70 configured on Unifi Switch wired network. Did not get an IP. Fixed an 192.168.70.x IP on laptop ethernet. Cannot ping VLAN70 gateway. Switch port set to vlan70 profile.
Same for Unifi wireless network. Does not get IP address. Fixed an IP. Cannot ping VLAN70 gateway. Switch port for Unifi AP set to All Profile.
The only difference between the video and my setup is that I do not have USG on Unifi Controller. That should not matter as I have read.
I suspect that I am getting it wrong on pfSense. No VLAN traffic at all. What did I get wrong? Thank you. -
-
Thank you, @Grimson
2 questions- Why do we make OPT and LAN the same vlan?
- I have not made the changes to the VLAN table. Do I need to add a VLAN group 4 for VLAN Tag 70 as show in the pic below?
-
@saunada said in pfSense Netgate SG-1100 and Unifi UniFi Switch 24 POE-250W Not Working:
- Why do we make OPT and LAN the same vlan?
You don't.
- I have not made the changes to the VLAN table. Do I need to add a VLAN group 4 for VLAN Tag 70 as show in the pic below?
You obviously need to tag your new VLAN on both ports of the switch.
