OpenVPN over Gateway group doesn't fail back
I am having the following issue with an OpenVPN client. I am running the lastest version of pfsense: 2.4.4-RELEASE-p3
I have a multi-WAN setup (WAN + 4G) and a gateway group FAILOVER_WAN configured as follows:
WAN - Tier 1 - Monitor IP: the public IP used as gateway for the connection
WAN_PPP - Tier 2 - Monitor IP: 184.108.40.206
Trigger - Packet loss or high latency (not relevant to the problem)
Outbound NAT disabled since I only need the routes received from the server.
For testing purposes, all interfaces have Permit on any protocol, any source, any destination in Firewall.
OpenVPN client using the FAILOVER_WAN as a source interface, connected to an OpenVPN server (not relevant to the issue, either).
If I disconnect the WAN, the gateway goes down and the OpenVPN service restarts and uses the 4G connection (Tier 2). All good so far.
The issue comes when I reconnect the WAN, the gateway status changes to UP, but the OpenVPN connection stays up over the 4G connection. A simple service restart solves the issue and OpenVPN client connects via the Tier 1 GW.
Any suggestion on how to make the OpenVPN client fail back to Tier 1 would be appreciated.
I have tried (seen on other discussions on this forum):
Use sticky connections - enabled/disabled
Flush all states when a gateway goes down - enabled/disabled
Default gateway IPv4 - Automatic/None/WAN_GW/WAN_PPP_GW
Added openvpn in Service Watchdog
The only workaround I can think of is adding a cron script to restart the service every hour or so, but it's not ellegant at all.
This post is deleted!
Thanks for the fast reply.
It is 100% set as such, since otherwise it wouldn't fail Tier1->Tier2
The issue is that OpenVPN doesn't switch back to Tier1 once it is available again (the system detects the GW back up, but I guess openvpn process needs to be restarted for it to reconnect using the preffered interface.)
I just found this client settings item in your post. (And deleted my answer)
It is so strange, I use completely the same scenario (ex. trigger) and my OVPN client reconnect back after main GW became available.
UPDATE: might have found the issue.
Tier 1 WAN interface was set up to receive IP via DHCP. I have changed this to static IP/SM/GW and now failover works great in both ways :) . Don't know what the underlying issue is. To be fair, the DHCP server I was using was kind of slow. It would lease the IP after >30 sec, I will do some more digging.
@robertko huh! I'm not sure that dhcp mode is the reason itself (my pf wan interfaces based on dhcp both) But slow dhcp lease process could affect restoring process. It is great that you solved it! Congrats!)