Speed test is slow direct from my PC to PFSense

billsecond

Yes, the values are very slow. If I hook up my home network to it and test to my web server through the PFSense Firewall, here is what I get:

Where as if I connect to it directly:

(I am not sure why its not showing closer to 3-4gbps, but its a newer server, have not looked at mtu or anything)

stephenw10

I assume you are testing over a 1G link there. igb NICs?

billsecond

Yes, both are 1Gb NICs and a a short Cat5e cable between the two.

stephenw10

But are they igb NICs as opposed to em or re etc?

billsecond

I guess I don't know what IGB vs EM vs RE are.
But I do see that the nics are IGB

stephenw10

Ok they're igb. They pretty much had to be unless you had added more since the C2758 has 4 igb NICs built into the SoC.

You should be seeing significantly more than that. I would check the output at the command line of top -aSH whilst testing.

Make sure you have all off loading disabled in Sys > Adv > Networking.

Check vmstat -i shows interrupt loading from each NIC spread across the cores.

Steve

Derelict

@billsecond said in Speed test is slow direct from my PC to PFSense:

I am not sure why its not showing closer to 3-4gbps

How do you expect to get more than 1Gb out of 1Gb NICs? You are going to need 10G to the ISP.

billsecond

@Derelict because when connected direct to the network I’m on 10gbps. Not through the router.

Derelict

Non-trivial to set up a lab like that. is virtualization involved? What switches etc?

Going to need more information. Guarantee the C2758 is capable of forwarding faster than you are seeing there, barring some strange issue with your particular unit.

billsecond

@Derelict
No, Virtualization is not involved, I have the nic in my personal PC directly connected via a cat6 cable to the device.

johnpoz

you happen to be doing any jumbo frames? Since your running 10ge and all.

stephenw10

The igb NICs are all 1G. You have 10G NICs in that firewall too?

Steve

billsecond

@stephenw10 said in Speed test is slow direct from my PC to PFSense:

The igb NICs are all 1G. You have 10G NICs in that firewall too?
Steve

Not on this one, this is my test device. But My point was that I was getting very slow speeds on this device. The device that I will be building is 10gb device. I was also explaining that if I hook up my PC direct to my existing non-test network (all 10gb), I do get a faster speed test.

stephenw10

Ok, so we are still looking at the ~250Mbps limit on a 1Gbps connection.

So do the tests I asked about here and we can check the results.

Steve

c0r3

Any update to this thread? im having the same problem with the bandwidth speed when using pfsense.

stephenw10

You should start a new thread for this and detail exactly what you're seeing and what you have done.
There are numerous reason you could be seeing less throughput that you expect. The chances you are hitting the same issue as the OP in this thread are low.

Steve