FRR OSPF Ext 1 Default Route With Unexpected Cost.
-
Hi. I configured FRR OSPFv2 to advertise an ext type 1 default route with a cost of 50. If I reset ospfd the LSA will show a cost of 50 but eventually the cost changes to 70. I'm at my wits end here. Can anybody spot anything in my config that would cause this behavior? Thanks.
Here is my config:
zebra.conf:
##################### DO NOT EDIT THIS FILE! ######################
###################################################################This file was created by an automatic configuration generator.
The contents of this file will be overwritten without warning!
###################################################################
password ********Accept Filters
ip prefix-list ACCEPTFILTER deny 10.254.6.20/30
ip prefix-list ACCEPTFILTER deny 10.254.6.22/32
ip prefix-list ACCEPTFILTER deny 0.0.0.0/0
ip prefix-list ACCEPTFILTER deny ::/0
ip prefix-list ACCEPTFILTER permit any
route-map ACCEPTFILTER permit 10
match ip address prefix-list ACCEPTFILTER
ip protocol ospf route-map ACCEPTFILTERospfd.conf:
##################### DO NOT EDIT THIS FILE! ######################
###################################################################This file was created by an automatic configuration generator.
The contents of this file will be overwritten without warning!
###################################################################
password ********
interface hn0
ip ospf network broadcast
ip ospf cost 1
ip ospf authentication message-digest
ip ospf message-digest-key 1 md5 ********
ip ospf priority 1
ip ospf mtu-ignore
ip ospf area 0.0.0.10
interface hn0.10
ip ospf cost 1
ip ospf area 0.0.0.10
interface hn3
ip ospf cost 1
ip ospf area 0.0.0.10
interface ovpnc1
ip ospf network point-to-point
ip ospf cost 30
ip ospf authentication message-digest
ip ospf message-digest-key 1 md5 ********
ip ospf dead-interval 20
ip ospf hello-interval 5
ip ospf area 0.0.0.10router ospf
ospf router-id 10.255.255.6
area 0.0.0.10 shortcut default
area 0.0.0.10 authentication message-digest
default-information originate metric 50 metric-type 1
ospf abr-type cisco
passive-interface hn0.10
passive-interface hn3 -
@0daymaster said in FRR OSPF Ext 1 Default Route With Unexpected Cost.:
default-information originate metric 50 metric-type 1
You can try to change metric-type 1 to metric-type 2 which is the default. It shouldnt change the costs then... as far as i understand that metric-type ...
