2.4.5 High latency and packet loss, not in a vm
-
My 2.4.4-p3 work without any problem for a long time... But when 2.4.5 came out I did an update as usual... Then problems with high latency started... I was even unable to get in WEB interface right after update restart, because of over 3000ms... After some time, lets say 20 sec. everything get back to normal... I have some friends who I gave internet and they are gamers... I have now 3 WAN set as failover, but every gets disconnected due to high latency on every single WAN at the same time...
I caught it happens every time when i do some config on interfaces and apply it... I also installed pfSense on another machine to test it and it behave the same...
This behavior is unacceptable, so I reverted to 2.4.4-p3 and everything is fine now :) Problem was in place even when I disconnect any of the ISP, because i think it sees this as interface reconfigure and make ping over 3000... -
I decided to downgrade the number of CPU's used in the VM.
Went from 32 core to 8 core. It had similar problems. Slow response in the webGUI and latency on monitored IP's.
Downgraded to 1 CORE and everything came up quickly and everything is working as expected.
No 100% CPU anymore and everything is responsive and packet loss is back to 0.0%.
-
@Cool_Corona said in 2.4.5 High latency and packet loss, not in a vm:
I decided to downgrade the number of CPU's used in the VM.
Went from 32 core to 8 core. It had similar problems. Slow response in the webGUI and latency on monitored IP's.
Downgraded to 1 CORE and everything came up quickly and everything is working as expected.
No 100% CPU anymore and everything is responsive and packet loss is back to 0.0%.
How do you change the number of cores? Is that an Intel thing or does it also apply to the AMD processors as well?
-
@jdeloach You can do that in a Virtual Machine, bare metal hardware not so much.
-
If you are using a virtualized system (like qemu-kvm, etc), you can decide whether to use the physical processor or a logical processor, with the desired characteristics and functionalities (such as the number of cores, extensions such as AES-NI etc.)
-
@jwj said in 2.4.5 High latency and packet loss, not in a vm:
@jdeloach You can do that in a Virtual Machine, bare metal hardware not so much.
Yeah, that is what I thought. Need some more coffee this morning. I haven't used virtual memory for running programs in the past. Will have to give that a try someday. Thanks.
-
@Cool_Corona said in 2.4.5 High latency and packet loss, not in a vm:
Downgraded to 1 CORE and everything came up quickly and everything is working as expected.
This is a great observation! Testing now.
-
2 Cores worked great for me on my test box, but when I went up to 8 cores like the production box, everything went downhill. luckily I changed the cores on the test box before I tried on the production box.
-
Heres my 3 month WAN latency graph showing the clear increase in average latency since the 2.4.5 upgrade. I just added this to my support ticket. I am not seeing a typical short timeframe ISP latency increase.
-
No idea if this is related, but I tried to add 2 monitor IPs to my v4 and v6 gateways and immediately I had latency and drops. Even when they were removed, I could barely get control of the web GUI. Had to reboot. Below are clips of top -aSH and proc load.
-
@provels That is exactly the bug, yup! Fix at the moment appears to be to drop to one vCPU if you're able.
-
@muppet Thanks. Think I'd rather keep the procs! My Hyper-V host is pretty lame!
-
@provels Then I suggest rolling back to your 2.4.4p3 snapshot.
-
@muppet It's just li'l ole me here. I have 2.4.4-p3, 2.4.5 UFS and 2.4.5 ZFS available on the lab.
-
I get timeouts when filter is reloading.
Still running 8 core setup and only minor issues. Its not production ready yet since it has timeouts when this happens:
Apr 16 22:06:33 xinetd 13368 Reconfigured: new=0 old=4 dropped=0 (services)
Apr 16 22:06:33 xinetd 13368 readjusting service 19001-udp
Apr 16 22:06:33 xinetd 13368 readjusting service 19001-tcp
Apr 16 22:06:33 xinetd 13368 readjusting service 19000-udp
Apr 16 22:06:33 xinetd 13368 readjusting service 19000-tcp
Apr 16 22:06:33 xinetd 13368 Swapping defaults
Apr 16 22:06:33 xinetd 13368 Starting reconfiguration
Apr 16 22:06:32 php-fpm 68319 /rc.openvpn: Gateway, none 'available' for inet6, use the first one configured. ''
Apr 16 22:06:32 php-fpm 68319 /rc.openvpn: Gateway, none 'available' for inet, use the first one configured. 'WANGW'
Apr 16 22:06:31 check_reload_status Reloading filter
Apr 16 22:06:31 check_reload_status Restarting OpenVPN tunnels/interfaces
Apr 16 22:06:31 check_reload_status Restarting ipsec tunnels
Apr 16 22:06:31 check_reload_status updating dyndns WANGW
Apr 16 22:06:31 rc.gateway_alarm 66212 >>> Gateway alarm: WANGW (Addr:81.19.224.67 Alarm:0 RTT:1.945ms RTTsd:.093ms Loss:14%)
Apr 16 22:04:44 xinetd 13368 Reconfigured: new=0 old=4 dropped=0 (services)
Apr 16 22:04:44 xinetd 13368 readjusting service 19001-udp
Apr 16 22:04:44 xinetd 13368 readjusting service 19001-tcp
Apr 16 22:04:44 xinetd 13368 readjusting service 19000-udp
Apr 16 22:04:44 xinetd 13368 readjusting service 19000-tcp
Apr 16 22:04:44 xinetd 13368 Swapping defaults
Apr 16 22:04:44 xinetd 13368 Starting reconfiguration
Apr 16 22:04:44 php-fpm 61919 /rc.openvpn: Gateway, none 'available' for inet6, use the first one configured. ''
Apr 16 22:04:44 php-fpm 61919 /rc.openvpn: Gateway, none 'available' for inet, use the first one configured. 'WANGW'
Apr 16 22:04:43 check_reload_status Reloading filter
Apr 16 22:04:43 check_reload_status Restarting OpenVPN tunnels/interfaces
Apr 16 22:04:43 check_reload_status Restarting ipsec tunnels
Apr 16 22:04:43 check_reload_status updating dyndns WANGW
Apr 16 22:04:43 rc.gateway_alarm 2496 >>> Gateway alarm: WANGW (Addr:81.19.224.67 Alarm:1 RTT:928.897ms RTTsd:5161.512ms Loss:18%)
Apr 16 22:04:00 xinetd 13368 Reconfigured: new=0 old=4 dropped=0 (services)
Apr 16 22:04:00 xinetd 13368 readjusting service 19001-udp
Apr 16 22:04:00 xinetd 13368 readjusting service 19001-tcp
Apr 16 22:04:00 xinetd 13368 readjusting service 19000-udp
Apr 16 22:04:00 xinetd 13368 readjusting service 19000-tcp
Apr 16 22:04:00 xinetd 13368 Swapping defaults
Apr 16 22:04:00 xinetd 13368 Starting reconfiguration
Apr 16 22:03:27 php-fpm 32951 /rc.openvpn: Gateway, none 'available' for inet6, use the first one configured. ''
Apr 16 22:03:27 php-fpm 32951 /rc.openvpn: Gateway, none 'available' for inet, use the first one configured. 'WANGW'
Apr 16 22:03:26 check_reload_status Reloading filter
Apr 16 22:03:26 check_reload_status Restarting OpenVPN tunnels/interfaces
Apr 16 22:03:26 check_reload_status Restarting ipsec tunnels
Apr 16 22:03:26 check_reload_status updating dyndns WANGW
Apr 16 22:03:26 rc.gateway_alarm 62528 >>> Gateway alarm: WANGW (Addr:81.19.224.67 Alarm:0 RTT:4.679ms RTTsd:26.791ms Loss:20%)
Apr 16 22:03:16 xinetd 13368 Reconfigured: new=0 old=4 dropped=0 (services)
Apr 16 22:03:16 xinetd 13368 readjusting service 19001-udp
Apr 16 22:03:16 xinetd 13368 readjusting service 19001-tcp
Apr 16 22:03:16 xinetd 13368 readjusting service 19000-udp
Apr 16 22:03:16 xinetd 13368 readjusting service 19000-tcp
Apr 16 22:03:16 xinetd 13368 Swapping defaults
Apr 16 22:03:16 xinetd 13368 Starting reconfiguration
Apr 16 22:03:16 php-fpm 19187 /rc.openvpn: Gateway, none 'available' for inet6, use the first one configured. ''
Apr 16 22:03:16 php-fpm 19187 /rc.openvpn: Gateway, none 'available' for inet, use the first one configured. 'WANGW'
Apr 16 22:03:15 check_reload_status Reloading filter
Apr 16 22:03:15 check_reload_status Restarting OpenVPN tunnels/interfaces
Apr 16 22:03:15 check_reload_status Restarting ipsec tunnels
Apr 16 22:03:15 check_reload_status updating dyndns WANGW
Apr 16 22:03:15 rc.gateway_alarm 38824 >>> Gateway alarm: WANGW (Addr:81.19.224.67 Alarm:1 RTT:1.923ms RTTsd:.079ms Loss:21%)
Apr 16 22:00:52 php [pfBlockerNG] No changes to Firewall rules, skipping Filter Reload
Apr 16 22:00:00 php [pfBlockerNG] Starting cron process.6 minutes where the network in unreachable.
-
This is all the same thing. We are past the point of 'is this a problem'. It is. Netgate is working on it. They have solicited configuration data and some users have provided that.
The impact of changing gateway configuration (monitor ip, polling freq, averaging time, etc) was reported at least once back on April 4 (look back in this thread) and acknowledged by Netgate.
The simplest way to manage this:
- If you can manage on 2.4.5 without disruption, stay put.
- If not, downgrade to 2.4.4-p3. Adjust the settings in System->Upgrade as needed.
Now we wait to see what happens, at some point 2.4.5-p1 will come out. When? I don't think anyone one knows at the moment.
Not in a passive mood? Open a ticket at Netgate Support and ask what you can provide that they would find helpful.
Just a note: When you post system log data with gateway alarms you might want to obscure your public IP, especially if it's a static IP. Just saying...
-
@jwj said in 2.4.5 High latency and packet loss, not in a vm:
This is all the same thing. We are past the point of 'is this a problem'. It is. Netgate is working on it. They have solicited configuration data and some users have provided that.
The impact of changing gateway configuration (monitor ip, polling freq, averaging time, etc) was reported at least once back on April 4 (look back in this thread) and acknowledged by Netgate.
The simplest way to manage this:
- If you can manage on 2.4.5 without disruption, stay put.
- If not, downgrade to 2.4.4-p3. Adjust the settings in System->Upgrade as needed.
Now we wait to see what happens, at some point 2.4.5-p1 will come out. When? I don't think anyone one knows at the moment.
Not in a passive mood? Open a ticket at Netgate Support and ask what you can provide that they would find helpful.
Just a note: When you post system log data with gateway alarms you might want to obscure your public IP, especially if it's a static IP. Just saying...
Its the monitor IP and not our own systems :)
-
Hyper-V VM
2,000,000 table entries
bogons enabled
pfBNG enabled
monitor IPs enabled
single core
no problem.Monitor IPs is the only thing that affected my system with 2 procs, all else same.
-
Yes, that's replicable everywhere I've tried it. The devs working on this are aware.
Steve
-
I have been told that this issue has been replicated in the Netgate lab and they working on a fix.
I would also remind all that are impatient for a fix to this issue that the support and development staff at Netgate have been challenged in ways no one could have predicted a few months ago. A massive surge in the need for remote access across their installed customer base and all that goes with that. They have offered up support to non-paying pfsense users as well as their customers on contract to meet these changing needs.
So, they are on it.
https://www.netgate.com/blog/usns-mercy-steps-up-its-network-for-covid-19-support.html
