No Access TO WAN from LAN when OpenVPN Client is in use

[zephyrhills]

I'm using OpenVPN client on my PFsense VM to pass some traffic through remote network.
Current setup is that all LAN port 80 traffic goes through OpenVPN client. While port 443 traffic should go directly to WAN.
Please see screenshots attached:

The problem is that 443 Port traffic doesn't go through when VPN client is connected. Only once I disconnect OpenVPN client traffic passes fine.

I appreciate any help on this.

[Zawi]

your question is not clear.

In general, if you need to Direct the traffic through specific GW use Policy Routing.
https://docs.netgate.com/pfsense/en/latest/routing/directing-traffic-with-policy-routing.html#directing-traffic-with-policy-routing

NAT rule is using to translate the addresses not to route the traffic.

[zephyrhills]

thank you, that helped!