Navigation

    Netgate Discussion Forum
    • Register
    • Login
    • Search
    • Categories
    • Recent
    • Tags
    • Popular
    • Users
    • Search

    TX Queues are not show shown in the TNSR CLI

    Feedback
    1
    1
    614
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • N
      NetFreak last edited by

      As you can see only rx-queues are shown in the cli:

      [tnsr@c01 ~]$ clixon_cli 
       
      Netgate TNSR Version: tnsr-v20.08-3
       
      This system is not configured for package updates.
      For information see 'show documentation'
       
      c01.fra.de.as49697.net tnsr# configure terminal 
      c01.fra.de.as49697.net tnsr(config)# dataplane dpdk dev 0000:00:13.0 network num-tx-queues 4
      c01.fra.de.as49697.net tnsr(config)# dataplane dpdk dev 0000:00:13.0 network num-rx-queues 4
      c01.fra.de.as49697.net tnsr(config)# exit
      c01.fra.de.as49697.net tnsr# show interface                                         
      Interface: eth0
          Description: "UPLINK"
          Admin status: up
          Link up, link-speed 10 Gbps, full duplex
          Link MTU: 9000 bytes
          MAC address: fa:ab:22:43:cc:35
          IPv4 MTU: 0 bytes
          IPv4 Route Table: ipv4-VRF:0
          IPv6 MTU: 0 bytes
          IPv6 Route Table: ipv6-VRF:0
          IPv6 addresses:
              fe80::f8ab:22ff:fe43:cc35/64
          VLAN tag rewrite: disable
          Rx-queues
              queue-id 0 : cpu-id 2
              queue-id 1 : cpu-id 3
              queue-id 2 : cpu-id 4
              queue-id 3 : cpu-id 5
      

      To check if it is really not configured i checked this in vpp cli:

      vpp# show hardware-interfaces 
                    Name                Idx   Link  Hardware
      eth0                               1     up   eth0
        Link speed: 10 Gbps
        Ethernet address fa:ab:22:43:cc:35
        Red Hat Virtio
          carrier up full duplex mtu 9206 
          flags: admin-up pmd maybe-multiseg subif
          Devargs: 
          rx: queues 4 (max 8), desc 256 (min 0 max 65535 align 1)
          tx: queues 4 (max 8), desc 256 (min 0 max 65535 align 1)
          pci: device 1af4:1000 subsystem 1af4:0001 address 0000:00:13.00 numa 0
          max rx packet len: 9728
          promiscuous: unicast off all-multicast on
          vlan offload: strip off filter off qinq off
      

      Could you please add this output to the clixion_cli? I think this would be helpfull for others as well :) Not everyone knows how to access the vppcli :)

      Joey

      1 Reply Last reply Reply Quote 3
      • First post
        Last post