Rule stopped working after ISP change
-
Gents,
I have two remote sites on my kids houses that I manage from home. My son is with Comcast, My daughter with at&t, I had both and my pfSense was configured to use Comcast as primary and at&t as fail over.
I've cancelled comcast and removed the extra configuration, so now only one IPv4 and one IPv6 GWs and no rules to control the fail over exists.
Before I could access both remote pfSenses from home without any issues.
After the change, I can only access my son's.
Here the configuration:
Two alias:
- Ports
- IPs
- Rule
Any ideas on how to troubleshoot this will be appreciated.
Regards,
Al -
@amello
Well, finished my tests and got it to work. No changes to the ISP equipment.
I might have a problem with that installation as changes are not applying after filters reloads. It takes over 5 minutes after it completes to start working.
The box is an i5-3470 with 4MB RAM and the it's running using 1% of the CPU, so no other reason for the delay I can think of, besides some garbage inside that install.
It is working now, but I can't say what caused to stop working in the first place (I do hate those it was working before and not it is not statement).
If I find out will post again.