Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Bug? If I enable Ipv6 on the DNSBL Webserver Configuration radvd won't start

1 Posts 1 Posters 195 Views 1 Watching

Log in to reply

L Offline

lohphat
last edited by

After upgrading to 21.02.2 from 21.02-p1 I notived no IPv6 addresses were in the NDP table.

After poking a bit the config line in the radvd.conf file was the RADNSS line for ::10.10.10.1 VIP address.

Once I disabled IPv6 and rebooted the router, client IPv6 autoconfig resumed.
SG-3100 26.03-RELEASE (arm) | Avahi (2.2_10) | iperf (3.0.6) | nmap (1.4.4_11) | ntopng (6.2.0) | openvpn-client-export (1.9.13) | pfBlockerNG-devel (3.2.16) | sudo (0.3.4) | System_Patches (2.3.3)
1 Reply Last reply
Reply Quote 0

Copyright 2026 Rubicon Communications LLC (Netgate). All rights reserved.
Privacy Policy · Cookie Policy

1 / 1