two openvpn
-
Hi Friends,
see if you can help me, I have a PFSense server so I set up 2 openvpn servers one for clients and one for external. But I need that from clients can access a port in external for example I have my client network in 10.9.0.x and the external in the 10.6.0.x and now in an external resource with ip 10.6.0.2 has published a service for example 10.6.0.2:8090 and I am not able to access that resource from the 10.9.0.x. Within the openvpn server options I set it to reach the 10.6.0.0.0 networks and I ping the 10.6.0.1 but I can not reach the 10.6.0.2 as additional data the 2 networks are added within the firewall so that they can be managed completely.
Regards
-
@juancho1981
Asside from a firewall rule allowing the access and the route in the access server settings, you have also to add the access server tunnel network to "Remote Networks" in the external client settings. -
Hello.
But if I have the network added in the tunnel, the problem is that I don't know where else to configure to get something I pass but I don't know where.
As I say I have configured the 2 OPENVPN OP1(external -10.6.0.0) and OP2(Development-10.9.0.0) but I am not able to get from the external network to the development network.
-
@juancho1981 said in two openvpn:
But if I have the network added in the tunnel
On both OpenVPN servers?
Post the routing table of both clients when they are connected.
Ensure that the destination device in 10.6.0.x doesn't block the access by its own firewall.