Design help for better control
-
If you pcap on the parent NIC in pfSense you can see what VLANs traffic is tagged with when it arrives.
-
I see it in the SFP+ going into Esx host.
Following these instruction to trace traffic for vmnic. No vlan traffic was captured.
https://docs.vmware.com/en/VMware-vSphere/7.0/com.vmware.vsphere.networking.doc/GUID-F1AC7100-FFBB-4414-9B70-E5537C15E192.html
Next step is to capture dropped packets. This will probably shed some light.
https://docs.vmware.com/en/VMware-vSphere/7.0/com.vmware.vsphere.networking.doc/GUID-84627D49-F449-4F77-B931-3C55E4A8ECA1.html -
Found out the setup requires vdswitch. Moving to physical.
-
@moosport said in Design help for better control:
vdswitch
So you have multiple esxi hosts? No mention of that
-
@johnpoz running the free version which only support vdswitch for first 60 days.
-
@moosport you sure do not need vdswitches to do vlans on esxi.. My point is you make no mention of having multiple esxi hosts in a cluster - nor do you show such a thing on your drawing.
-
@johnpoz
No multiple hosts. Just one host.
No vlan traffic is captured in vswitch. Only default vlan traffic is in the trace. -
@moosport well where did you come up with you need vdswitch then?
-
@moosport said in Design help for better control:
No vlan traffic is captured in vswitch
That has zero to do with vdswitch..
-
@johnpoz root cause analysis was suggested in a different forum.
Wire shark did capture vlan traffic on port going to ESX host. But pktcap-uw did not capture any on vmnic. Promiscuous mode was enabled too.
Switch configuration is correct.
Only data point which I still could not figure out is wireshark trace contains icmpv6 but not icmp dhcp discovery.
Neither ipv6 is enable on pfsense or unifi.