Wireguard Site-to-Site + Mobile connection only routes 1 side of tunnel
-
I followed the guide on this site and have a successful site-to-site connection. I added a second tunnel for mobile clients on site a. I can connect to the site a subnet but unable to connect to anything on site b. I tried adding site b subnet to allowed ips both in wireguard and in the wireguard client. No luck. I also tried adding another peer to the site-to-site connection but this breaks wireguard. How can I get access to both sites from my mobile connection? Appreciate any help.
Site A
local 10.20.10.0/24Site B
local 10.30.10.0/24 -
I got it. I created a NAT outbound rule allowing traffic from the mobile VPN.
-
Hi
Is possible explain?
My config:
Site A: 192.168.1.x
Site B: 192.168.2.xWG IP client Mobile: 10.10.10.3
The config the WG is in site A, all ok, but if acces to site B ( 192.168.2.x) is not possible.
How to
-
@xxnumbxx said in Wireguard Site-to-Site + Mobile connection only routes 1 side of tunnel:
I got it. I created a NAT outbound rule allowing traffic from the mobile VPN.
@xxnumbxx I tried this with no success.
Which side gets the outbound rule and which IP ranges go in the rule? Can you post an example please? -
J Jarhead referenced this topic on