Firewall rule problems. (Client-to-client forward)

[adminproconer]

Hi folks,
Is there an option in the pfsense like in mikrotik " client-to-client forward"?

I have 2 vlans:
Default: 192.168.0.0/24
DEV: 192.168.61.0/24

There is an instance where servers from "default" vlan, can't communicate with devices in "dev".

There is a device connected with serial port to eth adapter in the "dev" vlan, and this device can not be reached from "default" vlan, but from "dev" is accessible via smb.

The only 1 rule in "dev". Enable any IPv4 from any to any, and same for the "default".

Where should I start troubleshooting the issue?

The server from "default" can ping the "dev" GW what is 61.1 but nothing else in the network. (nmap -sn 192.168.61.0/24 -> 1 host up but there is connected WLAN devices too)

[viragomann]

@adminproconer said in Firewall rule problems. (Client-to-client forward):

Where should I start troubleshooting the issue?

With the network settings and firewall config of the concerned device.

Ensure that all devices in both subnets use pfSense as gateway.

If you can access a device from within it's own subnet, but not from another network segment check its firewall and ensure that it allows access from outside.