[solved] Bridge not working
-
I created a bridge from 3 LAN like interfaces. I "switched" the two System Tunables and have an allow any rule on the bridge, non on the interfaces. The same goes for ip configuration.
DHCP isn't working and also not manually.
Any hints regarding bridges to work?22.05-RELEASE
-
One time bump
-
@bob-dig I think we have about the same setup. Did you se the IP address on the bridge?
-
@fgervais Yes.
-
@bob-dig in the dhcp server page you see the bridge tab at the top?
-
@fgervais Yes ( I think, have removed the bridge for now)
-
@bob-dig humm that’s about all I did on my side I think.
-
@fgervais Thanks! Than my problem is probably related to the Hyper-V vSwitch I was using.
