GUI stuck after add IPsec tunnels
-
I just installed PfSense and after configure some IPsec tunnels at the moment that I applied the changes the website just freezes. I reboot the appliance from console command and then PfSense stuck on booting with the next message "Configuring IPsec VPN for dynamic hosts..." and this happens in each reboot.
After some time pfsense finally start, at that point the webgui works everywhere unless the dashboard, it get a lot of time to load.
This happens to me in three different computers so the hardware is not the problem.
Thanks for any help
-
Old thread, but should this be helpful I encountered this issue as well and resolved it by updating the router's DNS servers (i.e. to 8.8.8.8)