Wireguard does not care about gateway group configuration.

[frodet]

Hi,

I have a problem with the wireguard installation using a failover WAN setup.

I have this main WAN connection that is quite unstable. So I set up a 4G router on the OPT port on netgate 1100. This port is configured as a tier 2, and only used if main WAN connection is down. This works great for ordinary traffic, but not for wireguard. Wireguard fails over to OPT-port OK when WAN connection goes down. But not back when WAN connection is up again. I have to disable and then enable the opt port to manually change interface for wireguard.

Is this a bug?

[Bob.Dig]

@frodet So the heading is somewhat wrong. But looks like a bug to me.

[frodet]

Where can I report it?

[Bob.Dig]

@frodet Here. There is something already but it is closed for no good reason in hindsight.
Reading the comments, maybe disabling the keepalive helps...