Kernel panic with Wistron CM9 card
-
My ALIX 2D1 box has been working fine with the latest versions of nanobsd 1.2.3. The BIOS is up to date. It has 128 MB of RAM and a 2 GB CF card.
Today I installed a Wistron CM9 a/b/g card. On startup I get this in the console:
Copyright (c) 1992-2009 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD is a registered trademark of The FreeBSD Foundation. FreeBSD 7.2-RELEASE-p3 #0: Mon Sep 14 23:38:52 UTC 2009 sullrich@RELENG_1_2__FreeBSD_7_2_snapshots.pfsense.org:/usr/obj.pfSense/usr/pfSensesrc/src/sys/7 Timecounter "i8254" frequency 1193182 Hz quality 0 CPU: Geode(TM) Integrated Processor by AMD PCS (431.65-MHz 586-class CPU) Origin = "AuthenticAMD" Id = 0x5a2 Stepping = 2 Features=0x88a93d <fpu,de,pse,tsc,msr,cx8,sep,pge,cmov,clflush,mmx>AMD Features=0xc0400000 <mmx+,3dnow!+,3dnow!>real memory = 134217728 (128 MB) avail memory = 117420032 (111 MB) pnpbios: Bad PnP BIOS data checksum wlan: mac acl policy registered K6-family MTRR support enabled (2 registers) cryptosoft0: <software crypto=""> on motherboard pcib0: <host to="" pci="" bridge=""> pcibus 0 on motherboard pci0: <pci bus=""> on pcib0 Geode LX: PC Engines ALIX.2 v0.99h tinyBIOS V1.4a (C)1997-2007 pci0: <encrypt decrypt,="" entertainment="" crypto=""> at device 1.2 (no driver attached) vr0: <via 10="" vt6105m="" rhine="" iii="" 100basetx=""> port 0x1000-0x10ff mem 0xe0000000-0xe00000ff irq 10 at de0 vr0: Quirks: 0x2 vr0: Revision: 0x96 miibus0: <mii bus=""> on vr0 ukphy0: <generic ieee="" 802.3u="" media="" interface=""> PHY 1 on miibus0 ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto vr0: Ethernet address: 00:0d:b9:17:67:88 vr0: [ITHREAD] vr1: <via 10="" vt6105m="" rhine="" iii="" 100basetx=""> port 0x1400-0x14ff mem 0xe0040000-0xe00400ff irq 11 at de0 vr1: Quirks: 0x2 vr1: Revision: 0x96 miibus1: <mii bus=""> on vr1 ukphy1: <generic ieee="" 802.3u="" media="" interface=""> PHY 1 on miibus1 ukphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto vr1: Ethernet address: 00:0d:b9:17:67:89 vr1: [ITHREAD] vr2: <via 10="" vt6105m="" rhine="" iii="" 100basetx=""> port 0x1800-0x18ff mem 0xe0080000-0xe00800ff irq 15 at de0 vr2: Quirks: 0x2 vr2: Revision: 0x96 miibus2: <mii bus=""> on vr2 ukphy2: <generic ieee="" 802.3u="" media="" interface=""> PHY 1 on miibus2 ukphy2: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto vr2: Ethernet address: 00:0d:b9:17:67:8a vr2: [ITHREAD] ath0: <atheros 5212=""> mem 0xe00c0000-0xe00cffff irq 9 at device 12.0 on pci0 ath0: [ITHREAD] Fatal trap 12: page fault while in kernel mode fault virtual address = 0x6df4f958 fault code = supervisor read, page not present instruction pointer = 0x20:0x14 stack pointer = 0x28:0xc1020944 frame pointer = 0x28:0xc1020958 code segment = base 0x0, limit 0xfffff, type 0x1b = DPL 0, pres 1, def32 1, gran 1 processor eflags = interrupt enabled, resume, IOPL = 0 current process = 0 (swapper) trap number = 12 panic: page fault Uptime: 1s Automatic reboot in 15 seconds - press a key on the console to abort --> Press a key on the console to reboot, --> or switch off the system now. Rebooting...</atheros></generic></mii></via></generic></mii></via></generic></mii></via></encrypt></pci></host></software></mmx+,3dnow!+,3dnow!></fpu,de,pse,tsc,msr,cx8,sep,pge,cmov,clflush,mmx>Thanks for suggestions.
-
I have the same problem with the same wifi card (CM9 Atheros chipset) on a Soekris net5505
miibus5: <mii bus=""> on sis1 nsphyter1: <dp83815 10="" 100="" media="" interface=""> PHY 0 on miibus5 nsphyter1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto sis1: Ethernet address: 00:00:24:ca:df:d5 sis1: [ITHREAD] ath0: <atheros 5212=""> mem 0xa0010000-0xa001ffff irq 15 at device 17.0 on pci0 ath0: [ITHREAD] Fatal trap 1: privileged instruction fault while in kernel mode instruction pointer = 0x20:0x3 stack pointer = 0x28:0xc1020944 frame pointer = 0x28:0xc1020958 code segment = base 0x0, limit 0xfffff, type 0x1b = DPL 0, pres 1, def32 1, gran 1 processor eflags = interrupt enabled, resume, IOPL = 0 current process = 0 (swapper) trap number = 1 panic: privileged instruction fault</atheros></dp83815></mii>