Proxmox Web Interface not working When Shaw Modem is in Bridge Mode

[Papa_Dragon]

Hello,

I'm facing an issue with accessing the Proxmox web interface when my Shaw modem is set to bridge mode. I hope someone can provide some guidance or solutions to help resolve this problem.

Here's my situation:

When my Shaw modem is in bridge mode, I'm unable to access the Proxmox web interface using the local IP address (10.0.0.xx) assigned to my Proxmox server.
However, when I switch my Shaw modem back to its default mode, I regain access to the Proxmox web interface without any issues.
I suspect that the change in network configuration due to bridge mode is causing this problem. I would like to be able to access the Proxmox web interface even when my Shaw modem is in bridge mode. but i am unsure how.

I have tried the following troubleshooting steps:

changed the IP address to match my LAN IP range on proxmox server.

Thank you in advance for your help!

Best regards,

[tcorney]

@Papa_Dragon do you have another router on your network? Or is the Shaw device acting as your router? When the device is in bridge mode, the device will behave as a “plain modem” and will normally hand out a single, public IP address.

[Papa_Dragon]

@tcorney here is the whole other thread i have had for the past couple of days feel free to reply on this one https://forum.netgate.com/topic/180642/proxmox-web-interface-not-accessible-when-shaw-modem-is-in-bridge-mode/20?_=1686332965634