TNSR Load Balancing Methods

testv7

Hello everybody,

I'm new to TNSR and I'm evaluating the software.

so are there ways to load balance like a gateway group in pfsense? I want to use TNSR as an edge router in the ISP network and we have many wan interfaces.

Thanks.

fractal_boy

@testv7 well, TNSR is a fully functional router. You can do BGP with your ISP's and configure load balancing using BGP in the way you want, including ECMP.

testv7

@fractal_boy yes, but what to do if we don’t have our own IP addresses and ASN

jimp

Not yet, but maybe in the future.

fractal_boy

did you try something like this?

R1 tnsr(config)# sh run route
route table ipv4-VRF:0
    id 0
    route 0.0.0.0/0
        next-hop 0 via 10.100.1.2 e1
        next-hop 1 via 10.100.0.2 e2
    exit
exit

R1 tnsr(config)# sh route

Route Table ipv4-VRF:0  AF: ipv4  ID: 0
-----------------------------------------
0.0.0.0/0          via 10.100.0.2         e2 weight 1 preference 0
                   via 10.100.1.2         e1 weight 1 preference 0