pfSense® Plus software version 24.03-RELEASE is here! 🥳

coxhaus

@mwatch
I just upgraded to Pfsense 24.03. It seems to be working fine. It was a painless upgrade. It did what it was supposed to do and upgraded without issues. I think they did a fine job.

SteveITS

@mwatch Wow the new ZFS upgrade + restart is fast. That’s going to save us a bunch of time updating clients.

Mission-Ghost

Is there a good track record of successful 1100 updates? I’ve seen one post about a failed update possibly fit to failing nonvolatile storage but not much else.

Cylosoft

@Mission-Ghost We only had 1. No issues.

stephenw10

I've upgraded many without issue. However it is the lowest specced device so I would check the free drive space is at least 1.5GB. If it isn't look for old BE snapshots you might have.

I would also check the RAM usage. If you have a lot of packages installed you might need to disable any RAM hungry services.

Mission-Ghost

@stephenw10 very helpful, thank you.

I've got about 4.9G free. I have only one BE snapshot, which is of the stable baseline configuration now running.

Memory usage is about 57%. I intend to disable and perhaps remove all the installed packages prior to starting the upgrade process.

Phizix

@Mission-Ghost,

I have one 1100 but it only had one package installed - cron.

I did make sure it only had one ZFS configuration saved.

I had to update first to 23.09, before it would let me update to 24.03.

Afterward I decided to delete all but the original ZFS config.

No issues.

SteveITS

@Mission-Ghost said in pfSense Plus software version 24.03-RELEASE is here! 🥳:

Is there a good track record of successful 1100 updates? I’ve seen one post about a failed update possibly fit to failing nonvolatile storage but not much else.

FWIW we have two at the same client. One upgraded just fine, to 23.09.1 then 24.03. The other ran off the rails and only partially-upgraded to 23.09.1. I managed to recover it and save a trip out there. They were very similar/basically the same config, and I did uninstall pfBlocker on both before starting, so I don't know what the issue was on the one.

So, as per every upgrade for any software, have backups and a backup plan.

Phizix

I finally got around to updating my 8200.

I had to go through two versions before I could update to 24.03

I first removed all packages, etc.

Each update was VERY fast and successful.

WooooHoooo

Mission-Ghost

I applied the 24.03 update today to my 1100. Appears to have executed smoothly and rebooted back into production without issue.

Prior to executing the update, I removed all the packages. After the update, I reinstalled all the packages from scratch.

For some reason, some packages did not start automatically after installation including pfBlocker and Status Traffic Totals.

So I ran the pfBlocker download process and when that was complete it started up normally. I started Status Traffic Totals from the dashboard without incident.

My packages are:

Cron
Mailreport
pfBlockerNG
Service Watchdog
Status Traffic Total
System Patches

My plan is to run this in production for a week or so to verify stability and then update my shelf-spare 1100. This will complete my update cycle.