Netgate Discussion Forum
    • Categories
    • Recent
    • Tags
    • Popular
    • Users
    • Search
    • Register
    • Login

    Dual WAN, disable 1 WAN … different from pulling wire?!

    Scheduled Pinned Locked Moved webGUI
    2 Posts 1 Posters 179 Views
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • K
      khb
      last edited by

      Port 1 connected to comcast
      Port 3 connected to starlink
      Port 2 LAN

      Pull the Comcast wire, failover as expected ... traffic moves on wan2 without a hiccup.

      Use the GUI to disable WAN1/Port1 and dig, nslookup, ping all fail beyond disabling the interface what needs to be done to sw instigate failover?

      Any well known typical best traffic rules for getting the most of the somewhat mismatched performance curves of cable vs. starlink?

      K 1 Reply Last reply Reply Quote 0
      • K
        khb @khb
        last edited by

        Having gone ahead and created an explicit gateway group, with both WAN's Tier 1 .. and adjusting the LAN firewall rules to use that gateway group, enable/disable now works to simulate a wire pull for failover.

        I'll also note that performance is now very good, at peak 2x our previous best observed peaks (up+down)

        1 Reply Last reply Reply Quote 0
        • First post
          Last post
        Copyright 2025 Rubicon Communications LLC (Netgate). All rights reserved.