Enabling Filtering Bridge
-
I apologize in advance if this is a commonly asked question that I just am too blind to find an answer to, but here goes.
I have gone through the transpanent firewall tutorial and everything works wonderfully until I turn enable the filtering bridge. When this happens I can no longer access anything. Nothing internally, nothing externally. When I turn the filtering bridge off, everything works again.
I don't know what other information you need, probably lots, just let me know what else I should let you know and I'll do what I can to get it for you.
Thanks for any help you can give me
-
What version are you on? Did you create firewallrules for the traffic you want to pass at both involved interfaces?
-
I'm running RC2.
I set up rules for what I wanted and it didn't work. I also tried creating generic rules that would pass everything and that didn't work either so I'm kind of at a loss for what else to try.
Thanks again for any help.
-
Please use a recent snapshot: http://pfsense.com/~sullrich/1.0-SNAPSHOT-09-27-06/
-
I have updated to this snapshot and the same problem persists. Any other suggestions?
-
Show a screen shot of your custom rules and then run cat /tmp/rules.debug | grep USER from a shell/command prompt.