Pass thur Multi public ips via a routed /28 offen a /30 wan need help



  • I saw this on the board …

    I have tried it and Its works for outbound but I can't get it to work for inbound

    • ISP subnet: 1.1.1.204/30
    • WAN#1 subnet: 2.2.2.48/28

    ISP
              |
         pfSense
              |   |
    opt1-->|   |<---Lan Card
              |                  |
          Switch             Switch
              |                   |Connected to local lan PCs
              |
          Servers (with ip addresses in the WAN#1  subnets)

    The link between pfSense and the switch (opt1 interface of pfSense) (Lan interface is on anotherCard )

    Interfaces of pfSense:

    WAN - 1.1.1.206/30
    LAN - 192.168.0.1/24
    VLAN100 on LAN - 2.2.2.49/28

    I have outbound Manual Outbound NAT rule generation
             (AON - Advanced Outbound NAT) turned on

    With just this rules in place there

    WAN   192.168.0.0/24 * * * * * NO

    Rules for the networks are as followed

    Wan IPv4 * * * * * * none   router access  
    Rules IPv6 * * * * * * none


    Lan   IPv4 * * * * * * none      
    Rules IPv6 * * * * * * none


    Opt1 IPv4 * * * * * * none    
     Rules       IPv6 * * * * * * none

    What am I doing wrong can't seam to get it to allow connections in the servers via the public ips ...

    Can someone explain what kinda rules or whats wrong with is setup

    Those rules are just getting it to work then can fine tune it ..

    Thanks for all your hard work on this Great Program ..


Log in to reply